Fuser temperature too low. Lamp,
|
Код ошибки |
Описание |
|
F18 |
Paper lift did not complete |
|
F23 |
Toner motor |
|
F24 |
Pre clean lamp problem |
|
F26 |
Toner density sensor |
|
F34 |
Fuser overheat |
|
F35 |
Fuser temperature too low. Lamp, thermofuse open wire |
|
F36 |
Fuser temperature erratic. Probably thermistor |
|
F41 |
End of scan sensor not actuated |
|
F42 |
End of scan sensor not reached |
|
F43 |
CVR (copy lamp voltage regulator) |
|
F45 |
Lens or mirror movement problem |
|
F52 |
Drive problem |
|
F55 |
Zero cross. |
|
F56 |
Waste toner collector box is full. After replacing it, you must enter Код ошибки 94 in the 47 mode to reset |
|
F60 |
ADF/machine interface problem |
|
F67 |
ADF drive problem |
|
F70 |
Sorter/machine interface problem |
|
F77 |
Sorter bin problem |
|
F78 |
Stapler problem |
|
F86 |
Waste toner see 56 |
|
F98 |
Duplex problem |
|
J11 |
Upper cassette |
|
J12 |
Lower cassette |
|
J13, J14 |
Paper feed jam |
|
J15 |
Duplex unit jam |
|
J16, J17 |
Feed jam |
|
J19 |
Paper feed jam |
|
J31, J32 |
Exit jam |
|
J61 |
ADF opened during run |
|
J62, J63 |
ADF jam |
|
J65 |
RADF reverse jam |
|
J72 |
Sorter jam, or sorter interlock opened |
|
J75 |
Stapler jam |
|
J92-J94 |
Duplex stack gate sensor or other duplex problem |
|
J95 |
Duplex motor or duplex jam |
|
P17 |
Right door |
|
P19 |
Right door of paper feed unit |
|
P20 |
Drum not installed properly or toner level sensor connection problem |
|
P33 |
Left door |
|
P61 |
RADF reverse cover open |
|
P64 |
ADF was selected at the wrong time |
|
P71 |
Sorter interlock |
|
P74 |
Stapler overloaded, or paper left in stapler bin |
|
P76 |
Out of staples |
|
P81 |
Key counter not installed |
|
P82 |
Memory card problem |
|
P96 |
Paper in stacker when duplex selected |
|
P97 |
Used bypass in duplex mode |
|
P99 |
More than one side than the other in duplex |
